Immersion heater from 350 W get to buy in stores. These common immersion heaters for the household have an output of 350 to approx. 3500 W, correspondingly 1 liter of water is brought to the boil in 3-10 minutes. For travel there are also travel immersion heaters that only have a low output of 300 to 350 W. Immersion heaters are still used to prepare hot water in households without gas or when traveling, as well as on the camping site heat-resistant glass or metal) can be used.
The devices are operated in a water bath. On the one hand, the water must cover the entire heating area of the heating coil and, on the other hand, it must not come too close to the electrical connections in the handle. At the upper end of the heating element of the immersion heater there are often two markings (notches) that indicate the maximum and minimum water level.
Tubular heating element made of high quality stainless steel | Safety immersion heater with overheating protection | Nominal voltage: 230 V, power: 2000 W. | EAN: 4004369003043 | ||
thermally insulated handle with spacer for safe operation | Device length 27,5 cm | Diameter of the heating element - 58mm, length of the heating element together with the handle - 310mm | |||
€28,99 | €21,21 | €28,00 | €17,69 | N/A | N/A |
The Amazon | The Amazon | The Amazon | The Amazon | ||
21. March 2023 22: 20 | 22. March 2023 18: 29 | 22. March 2023 18: 29 | 22. March 2023 18: 29 | 22. March 2023 18: 29 | 22. March 2023 18: 29*Advertising |
The preparation of hot water with an immersion heater
When preparing hot water, there must be at least as much water in the pot that it is 2 cm above the spiral of the Immersion heater enough. If not enough water covers the heating coil of the immersion heater, the automatic switch-off will switch off the immersion heater. This automatic switch-off prevents a short circuit or the immersion heater from glowing out. This prevents greater damage. The water must not reach the handle of the immersion heater, as any leaks between the handle and the heating element can lead to a short circuit.
Do not use unattended
Immersion heaters that were used unsupervised have caused many house fires. The devices are almost maintenance-free. If there are limescale deposits on the heating coil, it is possible to boil them in a weak vinegar solution. If the immersion heater is damaged by corrosion or kinking, the immersion heater must no longer be used. Also, do not make any repairs to the plug or the electric cord itself.
The powerful flat immersion heater
With the powerful surface immersion heater from Speidel, freshly squeezed fruit juice can be heated to 85 ° C to 90 ° C directly in the barrel and then stored in the container without being transferred. This saves you from fiddling with the canning jar and filling the bottles with the finished juice.
Find in the Top🔟 the best & best-selling immersion heater products 2022 on Honest Tests
- Nominal voltage: 230 V, power: 2000 W.
- Diameter of the heating element - 58mm, length of the heating element together with the handle - 310mm
- The immersion heater is not suitable for boiling water in small containers such as glass or a small cup.
- Tubular heating element made of high quality stainless steel
- thermally insulated handle with spacer for safe operation
- Overheating protection, cable with kink protection
- Tubular heating element made of high quality stainless steel
- thermally insulated handle with spacer for safe operation
- Overheating protection, cable with kink protection
- Small tank rust remover, fits in almost all tanks, even through the smallest openings in moped and motorcycle tanks
- Small but high output of 300 watts
- Dimensions: total length: 16 cm, length of heating coil: 10 cm, diameter of heating coil: approx. 3,3 cm
- Safety immersion heater with overheating protection
- Device length 27,5 cm
- Cable length 80 cm
- High-quality, small and compact travel immersion heater made of stainless steel, MADE IN GERMANY!
- This immersion heater has the VDE test and the GS seal (tested safety).
- Power: 350 watts (220-240V)
- EAN: 4004369003043
- Rommelsba. Immersion heater 1000W TS 1001
- Nominal voltage: 230 V, power: 500 watts
- Fast water heating for instant beverages (tea, coffee, broth)
- Boil time 1 liter of water - about 12 minutes
Reading tips: coole DIY Projects | FITNESS | You like product testing read?
- Tested: cocktail shaker set by Godmorn
- Advent calendar with spices
- Test: Dyson V11 Animal Extra cordless vacuum cleaner
- Test: Aukey EP-T21 earbuds - 5 hours playing time and great bass
- Time Cube Test: Time management cubes for your effective time management
- Fast charging with Power Delivery | USB-PD | 65W UGREEN Fast Charger
* Product images & links | Source: Amazon PA API | Last update on 22.03.2023/XNUMX/XNUMX | * = Affiliate links | Prices quoted on this website may have changed. The actual price of a product can be found on the seller's website. Real-time updates are technically not possible. Prices including VAT plus shipping costs